220-9003, programming card for Comet controller

D-Power 9003 programming card for D-Power Comet controller

Programming card for configuring parameters of D-Power Comet regulators. Here, the controller is connected to the normal power connection to the map. The card itself is connected to the receiver battery.
The following controller parameters can be programmed with the map:

- Brake on / off
- Timing (Automatic 7-30 ° / low 7-22 ° / 22-30 ° high)
- Battery Type (LiPo / NiMH / NiCd)
- Termination voltage for LiPo (2.8V / 3.0 / 3.2)
- Start-up behavior (soft / normal / hard)
- Heli Mode (on / off)
- Direction of rotation (forward / reverse)
- Control frequency (8kHz for internal rotor motors / 16kHz for outrunner motors (Reduce power on / off) switch-off