Not available any more!!! archive items FUTABA Servo S3071HV MG S.Bus

Servo S3071MG-HV-S.Bus F1725

High Voltage and S.BUS execution of 100 Ncm powerful metal gear servos Power S3305/S3051HV.

The metal gear is designed to be extremely robust, which makes this servo for use in RC cars, but also in other model areas where high forces are required. A special potentiometer allows for precise positioning and neutral.
programmable
Of course, all S.BUS servos connected to receiver with conventional PWM modulation.
Addressing the servos can be done in several ways:
First About the S.BUS receiver
Second With the handy programmer SBC-1 no. F1696
Third About the PC-Link software, this USB adapter CIU-2, no. F1405 required.
4th On S.BUS connect the transmitter T18MZ

In addition, all S.BUS servos are programmable.
The following functions can be set:
- S.BUS channel assignment
- Servo reverse
- Servo type, normal - Retracts
- Soft start-up, on-off
- Mode selection of signal failure or Free Hold
- Soft Servo drive, on-off
- Servo position (servo tester)
- Servo center adjustment + / - 300 iS (about 30 degrees)
- Servo speed, 0.39 ... 9 seconds per 45 degrees
- Dead band setting
- Travel adjustment separated left and right, about 50 .. 175%
- Starting Power
- damping
- Holding force
- ID storage

Specifications

- Dimensions: 40 x 20 x 38.1 mm
- Servo Speed / 0.15s/45 / 0.14s/45 / 0.12 s/45
- Nominal voltage: / 6Volt/6.6Volt/7.40Volt
- Moment of force: / 95Ncm/100Ncm/105Ncm
- Weight: 49 g
- Temperature range: -15 ... +55 C
- Number of cells: 5 NiMH, 2S LiFe / LiPo
- Operating voltage: 6 .. 7.4 volts